Pallet Nailing and Processing Line
The Pallet Nailing and Processing Line is designed for pallets of different sizes, capable of nailing pallets and processing the nailed pallets without the need for additional equipment. In addition, only the pallet nailing machine can be used or corner cutting – milling – marking works can be done on the nailed pallets only with the processing group.
Technical Information
- Maximum Pallet Size That Can Be Nailed: 1100 mm - 1400 mm
- Minimum Driving Time: 1 Piece / 45 Sec.
- Nails to be used in the driving process: Cast Nails
- Nail Throwing Unit: Pneumatic
- Nail Driving Unit: PLC Control
- Car Movement: Servo motor
- Total Electricity Used in the Machine: 18.7 kW
- Dimensions: Width 240 cm x Length 320 cm x Height 300 cm
- Weight: 3450 kg
- Drive System: Roller Conveyor
- Centering Arm Movement: Pneumatic Piston
- Engine Power: 0.75 kW
* The section that cuts all four corners of the pallet at the same time.
- Saw Diameter: 250 mm
- Saw Movement: Pneumatic Piston
- Saw Motor Power: 4 x 3 kW
* It is the section that marks all 6 wedges of the pallet.
- Brand Heating System: Electric Resistance
- Brand Printing System: Pneumatic Piston
- Brand Stamp material: Chrome or Bronze
* The section that mills the inner and outer corners of the pallet’s bottom boards at a 45-degree angle.
* Six special chamfering blades
* Motor Power: Six 2.2 kW motors
* A section that rotates the pallet on the conveyor belt 90 degrees.
* Upper and lower pneumatic locking system
* Two pneumatic pistons
* It is a flipping section for nesting and stacking pallets.
- Pallet Rotation Motor: 0.75 kW
- Pallet Rolling System: Hydraulic
* The section that stacks the pallets on top of each other or inside each other.
- Stacking System: Hydraulic
- Maximum stacking: 20 pieces on top of each other
* Section where stacked pallets are kept
- Belt Motor Power: 1.1 kW
- It is controlled from the panel by a PLC system.
